IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAABC, Inc. has about fifty hosts in one LAN. The administrator would like to increase the throughput of that LAN. Which device will increase the number of collision domains and thereby increase the throughput of the LAN?ITExamAnswers asked 4 years ago • CCNAWhich type of transmission does a switch use when the destination MAC address is not contained in the MAC address table?ITExamAnswers asked 4 years ago • CCNAAn administrator purchases new Cisco switches that have a feature called StackPower. What is the purpose of this feature?ITExamAnswers asked 4 years ago • CCNAWhich switch form factor should be used when large port density, fault tolerance, and low price are important factors?ITExamAnswers asked 4 years ago • CCNAWhat does the cost of an OSPF link indicate?ITExamAnswers asked 4 years ago • CCNAOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. Fill in the blank. Do not use abbreviations.What is the missing command on S1?ITExamAnswers asked 4 years ago • CCNAA network administrator enters the command copy running-config startup-config. Which type of memory will the startup configuration be placed into?ITExamAnswers asked 4 years ago • CCNAFill in the blank. When a router receives a packet, it examines the destination address of the packet and looks in the Routing table to determine the best path to use to forward the packet.ITExamAnswers asked 4 years ago • CCNAIn order for packets to be sent to a remote destination, what three pieces of information must be configured on a host? (Choose three.)ITExamAnswers asked 4 years ago • CCNAWhich software is used for a network administrator to make the initial router configuration securely?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator issues the show ipv6 route command on R1. What two conclusions can be drawn from the routing table? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhich IP address is a valid network address?ITExamAnswers asked 4 years ago • CCNAWhat is the range of host IP addresses for the subnet 172.16.1.32/28?ITExamAnswers asked 4 years ago • CCNAAn organization has received the IPv6 network prefix of 2001:db8:1234::/52 from their ISP. How many subnets can be created from this prefix without borrowing bits from the interface ID?ITExamAnswers asked 4 years ago • CCNAWhich type of traffic would most likely have problems when passing through a NAT device?ITExamAnswers asked 4 years ago • CCNA