IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhen a wireless network in a small office is being set up, which type of IP addressing is typically used on the networked devices?IT Administrator asked 4 years ago • CCNA CyberOps, CCNAWhat Wi-Fi management frame is regularly broadcast by APs to announce their presence?IT Administrator asked 4 years ago • CCNA CyberOps, CCNAWhich type of wireless topology is created when two or more Basic Service Sets are interconnected by Ethernet?ITExamAnswers asked 4 years ago • CCNAWhich wireless network topology is being configured by a technician who is installing a keyboard, a mouse, and headphones, each of which uses Bluetooth?ITExamAnswers asked 4 years ago • CCNAWhich type of telecommunication technology is used to provide Internet access to vessels at sea?ITExamAnswers asked 2 years ago • CCNAIf three 802.11b access points need to be deployed in close proximity, which three frequency channels should be used? (Choose three.)ITExamAnswers asked 4 years ago • CCNAWhich protocol and port numbers are used by both IPv4 and IPv6 CAPWAP tunnels? (Choose two.)ITExamAnswers asked 2 years ago • CCNAWhich statement describes an autonomous access point?ITExamAnswers asked 3 years ago • CCNP, CCNAWhich characteristic describes a wireless client operating in active mode?IT Administrator asked 4 years ago • CCNA CyberOps, CCNAWhich method of wireless authentication is currently considered to be the strongest?ITExamAnswers asked 4 years ago • CCNAWhich feature of 802.11n wireless access points allows them to transmit data at faster speeds than previous versions of 802.11 Wi-Fi standards did?ITExamAnswers asked 4 years ago • CCNAWhere are dynamically learned MAC addresses stored when sticky learning is enabled with the switchport port-security mac-address sticky command?ITExamAnswers asked 4 years ago • CCNAA network administrator is configuring DAI on a switch. Which command should be used on the uplink interface that connects to a router?IT Administrator asked 3 years ago • CCNA, CCNA SecurityWhat Layer 2 attack is mitigated by disabling Dynamic Trunking Protocol?ITExamAnswers asked 3 years ago • CCNA, CCNA SecurityA network administrator is configuring DAI on a switch with the command ip arp inspection validate dst-mac . What is the purpose of this configuration command?IT Administrator asked 3 years ago • CCNA, CCNA Security