IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNP ROUTERefer to the exhibit. Assume router R2 does not have BGP enabled. However, the neighbor remote-as router configuration command has been entered on routers R1 and R3. Based on the information that is presented, which two statements are true? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. RTR-A and RTR-B cannot establish a BGP relationship. What could be the problem?ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. The BGP sessions are established between all routers. RTC receives route updates for network 170.10.0.0 from autonomous system 300 with the weight attribute set to 3000. RTB learns about network 170.10.0.0 from autonomous system 200 with a weight of 2000. Which router will be used by RTA as a next hop to reach network 170.10.0.0?ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. Which two commands need to be used on R1 and R2 to create a virtual link to and from area 0? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two variables must match between two OSPF routers to form a neighbor adjacency? (Choose two.)IT Administrator asked 4 years ago • CCNP, CCNP ROUTEOn an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?ITExamAnswers asked 3 years ago • CCNP, CCNP ROUTEWhat are two effective ways to prevent the EIGRP stuck-in-active problem? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two EIGRP and MPLS implementation statements are true? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. Router R1 is seeing routes that are advertised by router R2, and R2 is seeing routes that are advertised by R1. Which two statements are true when using EIGRP and an L3 MPLS VPN? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTERefer to the exhibit. Routers A and B have EIGRP configured and automatic summarization has been disabled on both routers. Which two router commands should be used to summarize the attached routes, and to which interface is this command applied? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two OSPF routing protocol characteristics can be used or modified at redistribution points to help implement a path control strategy? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhat is a characteristic of ADSL?ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two OSPFv3 statements are true? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich three statements are correct about the properties of an OSPF point-to-multipoint network type? (Choose three.)ITExamAnswers asked 1 year ago • CCNP ROUTEWhich two tasks should be conducted during the PPDIOO Prepare phase? (Choose two.)ITExamAnswers asked 1 year ago • CCNP ROUTE