IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP ROUTE
Which statement is true concerning OSPF messages when using OSPFv3 with address families?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which command is used to enable OSPFv3 using address families on an interface?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which IGP routing protocols use a 32-bit router-ID? Choose all that apply.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
In which routing protocol and type of active interface automatically enabled for that routing protocol? Choose two.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What must be done before RIPng can be enabled?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which VPN solution is used to better scale large IPsec hub-to-spoke and spoke-to-spoke networks?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is the IPv4 multicast address used by EIGRP?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which type of address is used to send traffic to a group of devices?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which command is used by a router to only announce a default route in it’s RIPng updates?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which mechanism optimizes the TCP window size by multiplying the product of the bandwidth times the round-trip delay?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which ICMPv6 message provides prefix, prefix length and default gateway information for an IPv6 device?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Assume that the ipv6 unicast-routing global configuration command has already been applied on a router. What is the effect of entering the ipv6 ospf 1 area 1 interface configuration command?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which statement about stateless autoconfiguration is true?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Assume all routers are running BGP sessions and both links are operational. Which procedure would ensure that AS1 routers use link 1.1.1.1 for packet transmittal to AS2?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is a characteristic of an IBGP session type?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
« Previous1…56789…16Next »
Ask Question