IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNP SWITCH v6.0Refer to the exhibit. Based on the debug ip dhcp server packet output, which statement is true?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. Which statement is true regarding the diagram and show ip route command output?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit and the show ip cef output. What can be concluded from the output?ITExamAnswers asked 11 months ago • CCNP SWITCH v6.0Refer to the exhibit and the partial configuration taken on routers RTA and RTB. All users can ping their gateways, but users on VLAN 5 and VLAN 10 cannot communicate with the users on VLAN 20. What should be done to solve the problem?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. What additional configuration is required for host A to receive IP configuration from the DHCP server?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which statement describes what occurs when a DHCP request is forwarded through a router that has been configured with the ip helper-address command?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0A client computer is set up for DHCP and needs an IP configuration. During the DHCP client configuration process, which response will enable the client to begin using the assigned address immediately?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0One switch in a Layer 2 switched spanning-tree domain is converted to PVRST+ using the spanning-tree mode rapid-pvst global configuration mode command. The remaining switches are running PVST+. What is the effect on the spanning-tree operation?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which protocol extends the IEEE 802.1w Rapid Spanning Tree (RST) algorithm to multiple spanning trees?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What happens when a switch running IEEE 802.1D receives a topology change message from the root bridge?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which two statements are true about STP root guard? (Choose two.)ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Which statement is true about UDLD?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What are three important steps in troubleshooting STP problems? (Choose three.)ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0Refer to the exhibit. STP is configured on all switches in the network. Recently, the user on workstation A lost connectivity to the rest of the network. At the same time, the administrator received the console message: %SPANTREE-2-RX_PORTFAST:Received BPDU on PortFast enable port.Disabling 2/1 What is the cause of the problem?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0What will happen when a BPDU is received on a loop guard port that is in a loop-inconsistent state?ITExamAnswers asked 3 years ago • CCNP, CCNP SWITCH v6.0