IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhich two symptoms would the show processes cpu command be helpful in troubleshooting? (Choose two.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. An administrator issues the show interfaces serial2/0 command. What are two possible causes of an increase in the number of input errors? (Choose two.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. What conclusion can be drawn from the exhibited output?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator uses ping commands to verify connectivity to the remote 172.16.1.0/24 network . On the basis of the exhibited output, what could be a possible cause for the failure of the second ping?ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator used an extended ping to verify connectivity to a remote location. The ping indicated a 50 percent packet loss. What could be the cause of the problem?ITExamAnswers asked 1 year ago • CCNPWhat are two situations where escalation of a case is recommended? (Choose two.)ITExamAnswers asked 1 year ago • CCNPRefer to the exhibit. A network administrator is troubleshooting a routing related problem. Which two facts can be concluded based on the generated output of the show logging command? (Choose two.)ITExamAnswers asked 1 year ago • CCNPWhat is a purpose of a disaster recovery plan?ITExamAnswers asked 1 year ago • CCNPWhich three types of data are useful for creating a baseline? (Choose three.)ITExamAnswers asked 1 year ago • CCNPWhich IOS feature can be leveraged to maintain current backups of all device configurations?ITExamAnswers asked 1 year ago • CCNPWhich two procedures can be implemented to ensure that current backups of all device configurations are maintained? (Choose two.)ITExamAnswers asked 1 year ago • CCNPA network administrator executes the show processes cpu command on a production router and notices that the average CPU load over the past 5 seconds was 97% and over the last one minute was around 39%. What should the administrator do next?ITExamAnswers asked 1 year ago • CCNPWhich Cisco IOS baseline performance tool can be used to measure delay and jitter across the network infrastructure?ITExamAnswers asked 1 year ago • CCNPWhich three IOS features can be used to keep the network documentation accurate? (Choose three.)ITExamAnswers asked 1 year ago • CCNPWhat type of information can be gathered by using SNMP during the process of collecting baseline information?ITExamAnswers asked 1 year ago • CCNP