IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPWhat operational feature is different for EIGRP for IPv6 compared to EIGRP for IPv4?ITExamAnswers asked 3 years ago • CCNPHow does EIGRP for IPv6 select a router ID if the router ID is not manually configured?ITExamAnswers asked 3 years ago • CCNPWhich two statements describe features of EIGRP implemented for IPv4 and IPv6? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich destination address is used for EIGRP query, update, and hello packets?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. An administrator attempts to configure EIGRP for IPv6 on a router and receives the error message that is shown. Which command must be issued by the administrator before EIGRP for IPv6 can be configured?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator is configuring BGP on router RT2, but RT2 cannot establish a peer relationship with RT1. What is the cause of the problem?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. R2 uses loopback0 interface 2.2.2.2 and R5 uses loopback0 interface 5.5.5.5 in the neighbor ip_address remote-as as_number statement in their respective configurations. A network administrator issues the show bgp ipv4 unicast summary command on R2. Which statement describes the adjacency state of R5?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Directly connected networks configured on router R1 are not being shared with neighboring routers through OSPFv3. What is the cause of the issue?ITExamAnswers asked 4 years ago • CCNPWhich technology creates a mapping of public IP addresses for remote tunnel spokes in a DMVPN configuration?IT Administrator asked 3 years ago • CCNPIn addition to configuring an IPv4 address and mask, and issuing the no shutdown command, which two additional commands does a network technician have to issue on the interface of a Cisco router to enable OSPFv3 address families for IPv4 on that interface? (Choose two.)IT Administrator asked 3 years ago • CCNPWhich type of OSPF LSA(s) can be represented with the label O*E2 in a routing table?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. An administrator is trying to configure R1 to run OSPFv3 but the neighbor adjacency is not forming with the router connected to Fa0/0. What is the cause of the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPThe show ip eigrp topology command output on a router displays a successor route and a feasible successor route to network 192.168.1.0/24. In order to improve network convergence, what does EIGRP do when the primary route to this network fails?ITExamAnswers asked 3 years ago • CCNPAn administrator is configuring an extended ACL for BGP route selection. Which ACE should the administrator issue to permit only 10.0.0.0 networks with a /16 through /32 prefix?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. From what location have the syslog messages been retrieved?ITExamAnswers asked 4 years ago • CCNA, CCNP