IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPAn administrator has chosen IPsec to encrypt DMVPN tunnels used to connect remote sites. How does the IPsec AH protocol differ from the IPsec ESP protocol?IT Administrator asked 3 years ago • CCNPA network administrator is teaching a junior engineer about MPLS Layer 3 VPNs. The administrator is explaining that a label stack is required for an MPLS domain to forward traffic. Which statement is accurate about a label stack?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Which two routers would perform penultimate hop popping? (Choose two.)IT Administrator asked 3 years ago • CCNPMatch the LSR component with the description. (Not all options are used.)IT Administrator asked 3 years ago • CCNPIn which situation would a company implement an OSPF NSSA?IT Administrator asked 3 years ago • CCNPWhen the distribute-list 1 in serial 0/0 command is used, which EIGRP routing updates would be permitted?ITExamAnswers asked 3 years ago • CCNPAn administrator is troubleshooting failing EIGRP route exchanges on routers R1 and R2. On further investigation it is discovered that the route exchanges were failing because the routers had duplicate router IDs. The router ID for R1 is changed using the eigrp router-id command, but the problem persists. Which additional action must be taken to enable the routers to exchange routes?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Based on the output shown, how are the OSPFv3 address families configured this router?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. OSPFv2 has been configured on router R1, and the router-id command has not been manually configured. When the network administrator reboots router R1, what will be the value of the OSPF router ID?IT Administrator asked 3 years ago • CCNPRefer to the exhibit. Router R1 has an OSPF neighbor relationship with the ISP router over the 192.168.0.32 network. The 192.168.0.36 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/0/1 100 was issued on R1 and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?IT Administrator asked 4 years ago • CCNP, CCNAWhich two statements describe OSPF? (Choose two.)IT Administrator asked 3 years ago • CCNPA boundary router is performing mutual redistribution between OSPF and EIGRP. What process should be taken to have an external EIGRP route preferred over an OSPF route to the same destination network?ITExamAnswers asked 3 years ago • CCNPAn administrator is troubleshooting an adjacency issue between two OSPF routers. Which two neighbor states indicate a stable adjacency between the routers? (Choose two.)IT Administrator asked 3 years ago • CCNPRefer to the exhibit. A network administrator is configuring EIGRP AS 20 on Router_2 and has received the error that is shown. What is the cause of the error?IT Administrator asked 3 years ago • CCNPOn what switch ports should BPDU guard be enabled to enhance STP stability?ITExamAnswers asked 4 years ago • CCNP, CCNA Security