IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNP
Refer to the exhibit. A network technician is troubleshooting missing OSPFv3 routes on a router. What is the cause of the problem based on the command output?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which command is used to enable OSPFv3 and address families on an interface?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Refer to the exhibit. A network administrator is configuring OSPF for R1 and R2, but the adjacency cannot be established. What is the cause of the issue?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
An administrator attempts to change the router ID on a router that is running OSPFv3 by changing the IPv4 address on the router loopback interface. Once the IPv4 address is changed, the administrator notes that the router ID did not change. What two actions can the administrator take so that the router will use the new IPv4 address as the router ID? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Under which configuration mode are OSPFv3 summarization commands issued?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is described by the interarea prefix LSAs sent by an OSPFv3 ABR?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
A network technician is configuring OSPFv3 with address families on a Cisco router. To verify the configuration the technician issues the show ospfv3 interface brief command. Which three items of information would the technician expect to be displayed? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
What are two features of OSPFv3? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Which OSPFv3 LSA type is used by ASBRs to announce routes learned through redistribution from other routing protocols?
IT Questions Bank 10IT Administrator asked 3 years ago • 
Refer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers as shown. The routers are unable to form a neighbor adjacency. What should be done to fix the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers but PC1 is unable to connect to PC2. What is the most likely problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What are two reasons that will prevent two routers from forming an OSPFv2 adjacency? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A company uses OSPF as its internal routing protocol. No routing protocol is used between the company and the ISP. The network administrator enters the following command on the router that connects to the ISP.
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
Refer to the exhibit. Why are routers R1 and R2 not able to establish an OSPF adjacency?​
IT Questions Bank 2ITExamAnswers asked 4 years ago • ,
A network engineer new to a company notices that a particular Layer 3 device participating in routing OSPF networks has an interface the engineer has not seen before in the output of the show ip ospf interface brief command. The interface is listed as VL0 and has a state of P2P with an OSPF neighbor. Which OSPF feature is the company using?
IT Questions Bank 2ITExamAnswers asked 3 years ago • 
« Previous1…8687888990…133Next »
Ask Question