IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNPBased on the configuration shown, what code will appear in the routing table for redistributed routes on the router?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. How will seed metrics be applied to routes redistributed into EIGRP?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. Two-way redistribution was configured between OSPF and EIGRP on R2. After the redistribution, R3 does not see any external routes coming from the EIGRP domain. The debug ip ospf database external output reveals that no external LSAs are generated for the routes. What could be the problem?ITExamAnswers asked 3 years ago • CCNPWhat is the default auto-increment sequence number value of a route map if none is specified?ITExamAnswers asked 3 years ago • CCNPWhich rule applies to route map statements?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. Where would the system administrator apply the following configuration to establish policy-based routing that directs packets from the 10.0.0.0/8 network through the R2 router to the Internet?ITExamAnswers asked 3 years ago • CCNPWhat are two operational characteristics of policy based routing? (Choose two.)ITExamAnswers asked 3 years ago • CCNPWhich prefix would match the prefix list ip prefix-list NAME seq 5 permit 10.0.0.0/8 ge 22 le 26 ?ITExamAnswers asked 3 years ago • CCNPWhich two network prefixes match the prefix match pattern 10.168.0.0/13 ge 24? (Choose two.)ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator issues the show bgp ipv6 unicast | begin Network command on router R1 to verify routes in the IPv6 BGP table. The administrator realizes that the route 2001:DB8:2::/64 learned from router R2 with IP address of 2.2.2.2 will not be installed in the routing table. What is a possible solution to the issue?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network technician is verifying the BGP configuration and peer relationship by using the show bgp ipv4 unicast summary command on router R1. Which conclusion can be drawn from the output?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator issues the show bgp ipv4 unicast 10.1.1.0 command on router R1 to verify the network 10.1.1.0 in the BGP table. The administrator notices that there are two routes to reach the network and the route through the neighbor 2.2.2.2 is the best route. Which configuration change can the administrator make on R1 to make the route through 3.3.3.3 the best-path?ITExamAnswers asked 3 years ago • CCNPRefer to the exhibit. A network administrator is troubleshooting a BGP adjacency issue between routers R2 and R5. R2 uses loopback0 interface 2.2.2.2 and R5 uses loopback0 interface 5.5.5.5 in the neighbor ip_address remote-as as_number statement in the configuration. However, an adjacency does not form. Which action can the administrator take to resolve the issue?ITExamAnswers asked 3 years ago • CCNPWhat are three issues that may cause the forming a BGP neighbor relationship to fail? (Choose three.)ITExamAnswers asked 3 years ago • CCNPWhat is the purpose of using the multi-exit discriminator attribute on multiple BGP routers in an AS?ITExamAnswers asked 3 years ago • CCNP