IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNPv8 ENARSI
Which LSA type exists in all OSPF areas?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What is the LSA Age field in the LSDB used for?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
True or false: A member router contains a complete copy of the LSDBs for every area in the routing domain.
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What is the advertised network for the loopback interface with IP address 10.123.4.1/30?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What command is configured to prevent a router from becoming the designated router for a network segment?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
True or false: The router with the highest IP address is the designated router when using a serial point-to-point link.
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
True or false: The OSPF process ID must match for routers to establish a neighbor adjacency.
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
True or false: OSPF is only enabled on a router interface by using the command network ip-address wildcard-mask area area-id under the OSPF router process.
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What destination addresses does OSPF use, when feasible? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
How does an EIGRP router indicate that a path computation is required for a specific route?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What is the default EIGRP hello timer for a high-speed interface?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What is an EIGRP successor?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
A network administrator is configuring IPv6 route summarization on a BGP router with the command aggregate-address 2001:db8::/60 summary-only . Which two component networks match the aggregated route? (Choose two.)
IT Questions Bank 14IT Administrator asked 4 years ago • ,
What is a requirement for member routers in a BGP peer group?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A network technician issues the show bgp ipv4 unicast summary command on router R1 to verify the BGP state with the neighbor. Which scenario would cause a neighbor relationship to fail?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous12345…19Next »
Ask Question