A LAN design uses a Layer 3 EtherChannel between two switches SW1 and SW2, with port-channel interface 1 used on both switches. SW1 uses ports G0/1 and G0/2 in the channel. However, only interface G0/1 is bundled into the channel and working. Think about the configuration settings on port G0/2 that could have existed before adding G0/2 to the EtherChannel. Which answers identify a setting that could prevent IOS from adding G0/2 to the Layer 3 EtherChannel? (Choose two answers.)
- A different STP cost (spanning-tree cost value)
- A different speed (speed value)
- A default setting for switchport (switchport)
- A different access VLAN (switchport access vlan vlan-id)
Explanation: With a Layer 3 EtherChannel, two configuration settings must be the same on all the physical ports, specifically the speed and duplex as set with the speed and duplex commands. Additionally, the physical ports and port-channel port must all have the no switchport command configured to make each act as a routed port.
So, having a different speed setting, or being configured with switchport rather than no switchport, would prevent IOS from adding interface G0/2 to the Layer 3 EtherChannel.
As for the wrong answers, both have to do with Layer 2 configuration settings. Once Layer 2 operations have been disabled because of the no switchport command, those settings related to Layer 2 that could cause problems on Layer 2 EtherChannels do not then cause problems for the Layer 3 EtherChannel. So, Layer 2 settings about access VLANs, trunking allowed lists, and STP settings, which must match before an interface can be added to a Layer 2 EtherChannel, do not matter for a Layer 3 EtherChannel.
Please login or Register to submit your answer