A LAN design uses a Layer 3 EtherChannel between two switches SW1 and SW2, with port-channel interface 1 used on both switches. SW1 uses ports G0/1, G0/2, and G0/3 in the channel. Which of the following are true about SW1’s configuration to make the channel be able to route IPv4 packets correctly? (Choose two answers.)

A LAN design uses a Layer 3 EtherChannel between two switches SW1 and SW2, with port-channel interface 1 used on both switches. SW1 uses ports G0/1, G0/2, and G0/3 in the channel. Which of the following are true about SW1’s configuration to make the channel be able to route IPv4 packets correctly? (Choose two answers.)

• The ip address command must be on the port-channel 1 interface.
• The ip address command must be on interface G0/1 (lowest numbered port).
• The port-channel 1 interface must be configured with the no switchport command.
• Interface G0/1 must be configured with the routedport command.

Explanation: With a Layer 3 EtherChannel, the physical ports and the port-channel interface must disable the behavior of acting like a switch port, and therefore act like a routed port, through the configuration of the no switchport interface subcommand.
(The routedport command is not an IOS command.) Once created, the physical interfaces should not have an IP address configured. The port-channel interface (the interface representing the EtherChannel) should be configured with the IP address.