A network administrator enters the following command sequence on a Cisco 3560 switch. What is the purpose of these commands?

IT Questions Bank › Category: CCNA › A network administrator enters the following command sequence on a Cisco 3560 switch. What is the purpose of these commands?

A network administrator enters the following command sequence on a Cisco 3560 switch. What is the purpose of these commands?

Switch(config)# interface gigabitethernet 0/1
Switch(config-if)# no switchport

to enable the Gi0/1 port as a switch virtual interface
to enable the Gi0/1 port as a bridge virtual interface
to make the Gi0/1 port a routed port
to shut down the Gi0/1 port

Explanation: By default, the physical ports on a 3560 switch are Layer 2 interfaces. To make them routed ports, the interface command no switchport should be used. The other options do not describe the purpose of this command.

Exam with this question: 4.5.4 Module Quiz - Inter-VLAN Routing Answers