A network administrator is configuring an EtherChannel link between switches SW1 and SW2 by using the command SW1(config-if-range)# channel-group 1 mode passive. Which command must be used on SW2 to enable this EtherChannel?
- SW2(config-if-range)# channel-group 1 mode auto
- SW2(config-if-range)# channel-group 1 mode active
- SW2(config-if-range)# channel-group 1 mode passive
- SW2(config-if-range)# channel-group 1 mode desirable
Explanation: The possible combinations to establish an EtherChannel between SW1 and SW2 using LACP or PAgP are as follows:
PAgP
on on
auto desirable
desirable desirable
LACP
on on
active active
passive active
The EtherChannel mode chosen on each side of the EtherChannel must be compatible in order to enable it.
Exam with this question: CCNA 3 (v5.0.3 + v6.0) Chapter 3 Exam Answers
Exam with this question: CCNA 3 (v5.0.3 + v6.0) Chapter 4 Exam Answers
Please login or Register to submit your answer