An administrator is attempting to configure a static route on a Cisco 2960 series switch. After the administrator types the command ip route 0.0.0.0 0.0.0.0 10.1.1.1, an error message appears stating that the command is not recognized. What must the administrator do so that this command is accepted?

Jul 14, 2020 Last Updated: Jul 14, 2020 No Comments

IT Questions Bank › An administrator is attempting to configure a static route on a Cisco 2960 series switch. After the administrator types the command ip route 0.0.0.0 0.0.0.0 10.1.1.1, an error message appears stating that the command is not recognized. What must the administrator do so that this command is accepted?

Question:
An administrator is attempting to configure a static route on a Cisco 2960 series switch. After the administrator types the command ip route 0.0.0.0 0.0.0.0 10.1.1.1, an error message appears stating that the command is not recognized. What must the administrator do so that this command is accepted?

Enter the command no switchport.
Enter the command ipv6 unicast-routing.
Enter the command ip route 0.0.0.0 0.0.0.0. vlan 10.
Enter the command sdm prefer lanbase-routing and reload.

Exam with this question: CCNA 2 (v5.0.3 + v6.0) Chapter 5 Exam Answers