An administrator is configuring IPv6 on a router. The steps that have already been completed are: What is the remaining step to complete the activation of RIPng?

IT Questions Bank › Category: CCNA Discovery v4 › An administrator is configuring IPv6 on a router. The steps that have already been completed are: What is the remaining step to complete the activation of RIPng?

An administrator is configuring IPv6 on a router. The steps that have already been completed are:

1. Activate IPv6 traffic forwarding.
2. Configure IPv6 addresses.
3. Globally configure RIPng.

What is the remaining step to complete the activation of RIPng?

Enter the ipv6 router rip name command and then use network statements to activate RIPng on the interfaces.
Enter the ipv6 router rip name command and then specify which interfaces run RIPng, which are passive, and which only receive.
Enter the interface mode for each IPv6 interface and enable RIPng with the ipv6 rip name enable command.
Enter the interface mode for each IPv6 interface and enable the multicast group FF02::9, and then activate RIPng globally using the ipv6 router rip name command.
Enter the router rip command, and then activate RIPng using the version command. RIPng then automatically runs on all IPv6 interfaces.

Exam with this question: CCNA Discovery 4: DCompNtwk Chapter 6 Exam