An organization requires that LAN clients generate their IPv6 configuration using SLAAC. You have configured the IPv6 GUA on the router LAN interface and verified that the interface is UP. However, hosts are not generating an IPv6 GUA. Which other command should be configured to enable SLAAC?

Jan 9, 2023 Last Updated: Jan 9, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA 2 v7 › An organization requires that LAN clients generate their IPv6 configuration using SLAAC. You have configured the IPv6 GUA on the router LAN interface and verified that the interface is UP. However, hosts are not generating an IPv6 GUA. Which other command should be configured to enable SLAAC?

An organization requires that LAN clients generate their IPv6 configuration using SLAAC. You have configured the IPv6 GUA on the router LAN interface and verified that the interface is UP. However, hosts are not generating an IPv6 GUA. Which other command should be configured to enable SLAAC?

  • R1(config)# ipv6 dhcp pool pool-name
  • R1(config)# ipv6 unicast-routing
  • R1(config-if)# ipv6 enable
  • R1(config-if)# ipv6 nd other-config-flag

Explanation: For a router to be able to send RA messages, it must be enabled as an IPv6 router using the ipv6 unicast-routing global config command.

Exam with this question: 8.5.3 Module Quiz - SLAAC and DHCPv6

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments