Fill in the blanks. To configure a routed port, the interface must be put into Layer 3 mode by using the ____ interface configuration command. After this, the interface must be assigned an ____ address.

Jan 20, 2023 Last Updated: Jan 20, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA 1 v6 › Fill in the blanks. To configure a routed port, the interface must be put into Layer 3 mode by using the ____ interface configuration command. After this, the interface must be assigned an ____ address.

Fill in the blanks.

To configure a routed port, the interface must be put into Layer 3 mode by using the ____ interface configuration command. After this, the interface must be assigned an ____ address.

no switchport, IP

Exam with this question: CCNA 1 ITNv6 Chapter 5: Check Your Understanding

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments