IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it Refer to the exhibit. Which two routes are considered parent routes? (Choose two.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich characteristic can be used to determine if a route is an ultimate route?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. What three types of routes are displayed in this routing table? (Choose three).ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. What can be determined from this output?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. If all routers are running RIP version 2, why is there no route for the 192.168.1.32/27 network?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERoutingRefer to the exhibit. The exhibit shows partial results from the debug ip rip events command on router B. What is the likely cause of the debug messages?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingHow do RIP v1 and RIP v2 differ?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat condition would RIPv2 allow that RIPv1 would not allow?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat is the default behavior of the RIP routing protocol if no version type is specified?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich statement regarding RIPv2 is correct?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat two commands will determine whether auto-summarization is in effect for RIP? (Choose two.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. The network administrator wants to minimize the number of entries in Router1’s routing table. What should the administrator implement on the network?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERoutingCategorize each address by placing it in the appropriate group. Not all items are used.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingHow many bits are used in the IPv4 address space?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. A network engineer is summarizing the two groups of routes on router R1 shown in the exhibit. Which summarization will work for all the subnets?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v4.0 ERouting