IT Questions Bank Observe the graphic. Which command correctly configures a static default route on R1?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. What command was used on Router1 to produce the output shown in the graphic?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. The network administrator must remove the route to the 10.0.0.0 network. What command will accomplish this task?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich statement is true concerning configuring static routes using next-hop addresses?ITExamAnswers asked 9 months ago • CCNA 2 v4.0 ERouting, CCNA 2 v5Refer to the exhibit. Which two commands must be configured to allow communication between the 192.168.1.0/24 and 10.0.0.0/8 networks? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingThe network administrator configured the ip route 0.0.0.0 0.0.0.0 serial 0/0 command on the router. How will this command appear in the routing table assuming the serial0/0 interface is up?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. Which port is used to connect a router to a LAN switch?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich statement is true regarding metrics used by routing protocols?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat two statements are correct regarding how a router forwards packets? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingA network engineer is configuring a new router. The interfaces have been configured with IP addresses but no routing protocols or static routes have been configured yet. What routes are present in the routing table?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhat two tasks do dynamic routing protocols perform? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4.0 ERouting, CCNA 2 v6, CCNA 3 v6Which routing principle is correct?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich of the following commands will set the privileged mode password to “quiz”?ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingWhich two commands can a technician use to determine if router serial ports have IP addresses that are assigned to them? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERoutingConstruct the sequence of events that occurs during the router startup process. (Not all options apply.)ITExamAnswers asked 3 months ago • CCNA 2 v4.0 ERouting