IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it Which two statements are true about half-duplex and full-duplex communications? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, Network Addressing and Basic TroubleshootingWhich utility shows the route a packet takes to reach its destination?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhat does it mean when the ping command returns a result of “.”?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkA network administrator must configure a serial interface with an IP address. The configuration must also identify the remote site to which the interface is connected. Which set of commands will meet these requirements?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkAn administrator configures a new router and names it SANJOSE. The administrator needs to set a password that will be required to establish a console session with the router. What commands should be issued by the administrator to set the console password to CISCO?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhat command will display a list of commands available for viewing the status of the router?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhich command will display statistics for all interfaces configured on a router?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhat is the purpose of the IOS enable secret command?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhich command turns on a router interface?ITExamAnswers asked 9 months ago • CCNA 1 v4.0 ENetwork, CCNA Discovery v4Which command sequence will permit access to five virtual terminal lines with a password of cisco?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkA copy of a configuration file can be saved to a TFTP server. Construct the command sequence to accomplish this task. (Not all options apply.)ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhat primary factor should be addressed before using wireless technology?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkWhich UTP cable lengths are specified by ANSI/TIA/EIA-568-B standards? (Choose three.)ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkRefer to the exhibit. Which option defines the default port configuration settings used to establish this direct serial connection between a computer and a Cisco networking device?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetworkRefer to the exhibit. What type of cable connects the two routers together without any intermediary device?ITExamAnswers asked 5 months ago • CCNA 1 v4.0 ENetwork