IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

Pages 1

If the start-up configuration is not found in NVRAM, where will the router look for it next by default?
Pages 2ITExamAnswers asked 9 months ago • 
Refer to the exhibit. The network administrator has added networks A and B to router R1. Which two subnetwork numbers should be used to address networks A and B so that these networks use the same subnet mask as networks C and D? (Choose two.)
Pages 2ITExamAnswers asked 9 months ago • 
A building has experienced a power outage. When the power returns, none of the devices on one floor can access the Internet. The network administrator checks the switch in the IDF that these devices are connected to and notes that the SYST LED on the front of the switch is amber. What is a possible cause of this problem?
Pages 2ITExamAnswers asked 9 months ago • 
will occur if connectivity with the other host is
Pages 2ITExamAnswers asked 9 months ago • 
Refer to the exhibit. The network administrator uses the command below to configure a default route on RTB: RTB(config)# ip route 0.0.0.0 0.0.0.0 fa0/0 A ping issued from PC3 is successful to RTB. However, echo request packets arrive at PC1 but the echo replies do not make it back to PC3. What will fix this problem?
Pages 2ITExamAnswers asked 9 months ago • 
Refer to the exhibit. Which combination of cable types should be used to complete the connection?
Pages 2ITExamAnswers asked 9 months ago • 
What is an example of a dedicated point-to-point WAN link?
Pages 2ITExamAnswers asked 9 months ago • 
Refer to the exhibit. What does the highlighted value 120 represent?
Pages 2ITExamAnswers asked 9 months ago • 
Which two parameters are stored in the routing table? (Choose two.)
Pages 2ITExamAnswers asked 9 months ago • 
Which address does a switch use for implementing port security?
Pages 2ITExamAnswers asked 9 months ago • 
Refer to the exhibit. A computer with the displayed IP settings is unable to access a server on the 192.168.2.0 network using the server IP address but can access hosts on the 192.168.1.0 network. What should the network administrator do to troubleshoot this problem?
Pages 2ITExamAnswers asked 9 months ago • 
What are three features of the TCP protocol? (Choose three.)
Pages 2ITExamAnswers asked 9 months ago • 
How many host addresses can be assigned in each subnetwork when using network address 172.16.0.0 with subnet mask 255.255.252.0?
Pages 2ITExamAnswers asked 9 months ago • 
What is a feature of PAT?
Pages 2ITExamAnswers asked 9 months ago • 
When does a router enter the setup mode?
Pages 2ITExamAnswers asked 9 months ago • 
« Previous1…8586878889…1,321Next »
Ask Question