IT Questions Bank What is the correct command sequence to configure a router host name to ‘LAB_A’?ITExamAnswers asked 8 months ago • CCNA Discovery v4Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4, CCNA Discovery v4, CCNA Security, Networking Devices and Initial Configuration, Networking EssentialsA technician has made changes to the configuration of a router. What command will allow the technician to view the current configuration before he saves the changes?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. A company always uses the last valid IP address in a subnetwork as the IP address of the router LAN interface. A network administrator is using a laptop to configure switch X with a default gateway. Assuming that the switch IP address is 192.168.5.147/24, what command will the administrator use to assign a default gateway to the switch?ITExamAnswers asked 8 months ago • CCNA Discovery v4How does the SYST LED on the catalyst 2960 switch indicate a POST failure?ITExamAnswers asked 8 months ago • CCNA Discovery v4In what two ways does SDM differ from the IOS CLI? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which password or passwords will be encrypted as a result of the configuration that is shown?ITExamAnswers asked 8 months ago • CCNA Discovery v4Which mode will a configured router display at login?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which three sets of commands are required to enable administrators to connect to the Switch1 console over Telnet for configuration and management? (Choose three.)ITExamAnswers asked 8 months ago • CCNA Discovery v4What are three advantages of NAT implementations? (Choose three.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Static NAT works by mapping a specific inside local IP address to what other specific address type?ITExamAnswers asked 8 months ago • CCNA Discovery v4Which port numbers are used by PAT to create unique global addresses?ITExamAnswers asked 8 months ago • CCNA Discovery v4What must happen for a privately addressed host on an inside local network to be able to communicate with an outside destination host on the Internet?ITExamAnswers asked 8 months ago • CCNA Discovery v4What are two reasons that NAT was developed? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Which option shows the proper notation for an IPv6 address?ITExamAnswers asked 4 years ago • CCNA Discovery v4