Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

IT Questions Bank › Category: CCNA › Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

Question:
Refer to the exhibit. An administrator is trying to troubleshoot connectivity between PC1 and PC2 and uses the tracert command from PC1 to do it. Based on the displayed output, where should the administrator begin troubleshooting?

Explanation: Tracert is used to trace the path a packet takes. The only successful response was from the first device along the path on the same LAN as the sending host. The first device is the default gateway on router R1. The administrator should therefore start troubleshooting at R1.

Exam with this question: CCNA 1 v7 Modules 11 – 13 Exam Answers
Exam with this question: CCNA 1 (v5.1 + v6.0) Chapter 11 Exam Answers
Exam with this question: CyberOps Associate Final Exam Answers
Exam with this question: Networking Basics Course Final Exam