Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem?

Dec 1, 2022 Last Updated: Dec 1, 2022 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA 3 v4 › Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem?

Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is the most likely cause of this problem?

  • There is a native VLAN mismatch.
  • The link between Switch1 and Switch2 is up but not trunked.
  • The router is not properly configured for inter-VLAN routing.
  • VLAN 50 is not allowed to entering the trunk between Switch1 and Switch2.

Exam with this question: CCNA Exploration 3: ESwitching Chapter 3 Exam

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments
0
Would love your thoughts, please comment.x
()
x