Refer to the exhibit. The two switches that are shown will not form a trunk. What is the most likely cause of this problem?

Dec 16, 2023 Last Updated: Dec 16, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNA Discovery v4 › Refer to the exhibit. The two switches that are shown will not form a trunk. What is the most likely cause of this problem?

Refer to the exhibit. The two switches that are shown will not form a trunk. What is the most likely cause of this problem?

  • The native VLANs are improperly configured.
  • All the hosts are on the same VLAN and a trunk is not needed.
  • Both ports are set to dynamic auto.
  • The trunk should be configured using the switchport mode access command.

Exam with this question: CCNA Discovery 4: DCompNtwk Final Exam

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments