Which command is used to enable OSPFv3 using address families on an interface?

Mar 25, 2023 Last Updated: Mar 25, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNP ROUTE › Which command is used to enable OSPFv3 using address families on an interface?

Which command is used to enable OSPFv3 using address families on an interface?

  • Router(config-if)# ospfv3 pid [ ipv4 | ipv6 ] area area-id
  • Router(config-router-af)# network prefix/prefix-length area area-id
  • Router(config-if)#[ ipv4 | ipv6 ] ospfv3 area area-id
  • Router(config-router-af)# prefix/prefix-length area area-id activate

Exam with this question: CCNP ROUTE Final Exam Answers (Version 7)

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments