Which command would configure an R1 interface to obtain its IP address information using stateless DHCPv6?

Mar 24, 2023 Last Updated: Mar 24, 2023 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNP ROUTE › Which command would configure an R1 interface to obtain its IP address information using stateless DHCPv6?

Which command would configure an R1 interface to obtain its IP address information using stateless DHCPv6?

  • R1(config-if)# ipv6 address dhcpv6
  • R1(config-if)# ipv6 address dhcp
  • R1(config-if)# ipv6 address autoconfig
  • R1(config-if)# ipv6 address slaac

Exam with this question: CCNP ROUTE Chapter 6 Exam Answers (Version 7)

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments