While troubleshooting a Frame Relay link, the network administrator executes the show ip interface brief command on both sides of the PVC link. All interfaces show a configured IP address and that the line protocol is up. Further investigation reveals that the IP address of the remote router does not appear in the Frame Relay table. Which step would solve this problem?

While troubleshooting a Frame Relay link, the network administrator executes the show ip interface brief command on both sides of the PVC link. All interfaces show a configured IP address and that the line protocol is up. Further investigation reveals that the IP address of the remote router does not appear in the Frame Relay table. Which step would solve this problem?

• Change the LMI type on the local router.
• Verify that the DLCI number is the same on both sides of the PVC.
• Configure the router using the frame-relay map ip command.
• Verify that the remote router has Frame Relay encapsulation enabled.

Exam with this question: CCNA Discovery 4: DCompNtwk Practice Final Exam