IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4Refer to the exhibit. When a static IP address is being configured on the host, what address should be used for the default gateway?ITExamAnswers asked 11 months ago • CCNA 2 v4When presented with multiple valid routes to a destination, what criteria does a router use to determine which routes to add to the routing table?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. What is the meaning of the highlighted value 120?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. The router receives a packet that is destined for 192.168.5.79. How will the router handle this packet?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. How many routes are ultimate routes?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator adds this command to router R1: ip route 192.168.2.0 255.255.255.0 S0/0/0. What is the result of adding this command?ITExamAnswers asked 11 months ago • CCNA 2 v4Which router component contains a scaled-down version of the IOS that can be used to reload a complete version of the IOS in the event that the IOS becomes damaged or corrupted?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. A network engineer has run the show version command on R3. Upon rebooting, R3 does not load the start-up configuration settings. What could be the cause of this problem?ITExamAnswers asked 11 months ago • CCNA 2 v4Refer to the exhibit. R1 and R2 are both configured with RIPv1. Beginning from global configuration mode, what comand or commands will eliminate RIP updates on the Ethernet segment of R2?ITExamAnswers asked 2 years ago • CCNA 2 v4The command ip route 192.168.2.0 255.255.255.0 172.16.2.2 was entered into the router. After network changes were made, the new next hop for the 192.168.2.0/24 network is 172.16.5.1. What should an administrator do so that the router will use the new next hop to reach the 192.168.2.0 network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are running the same routing protocol. Based on the exhibit and its displayed commands, which statement is true?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A router learns a route to the 192.168.6.0 network, as shown in the output of the show ip rip database command. However, upon running the show ip route command, the network administrator sees that the router has installed a different route to the 192.168.6.0 network learned via EIGRP. What could be the reason for the missing RIP route?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. R2 is configured correctly. The network administrator has configured R1 as shown. Which two facts can be deduced from the configuration of R1? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. While trying to diagnose a routing problem in the network, the network administrator runs the debug ip rip command. What can be determined from the output of this command?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. An administrator is adding a new subnet of 50 hosts to R3. Which subnet address should be used for the new subnet that provides enough addresses while wasting a minimum of addresses?ITExamAnswers asked 2 years ago • CCNA 2 v4