IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 2 v4
Refer to the exhibit. All interfaces are addressed and functioning correctly. The network administrator runs the tracert command on host A. Which two facts could be responsible for the output of this command? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which component is typically used to connect the WIC interface of a router to a CSU/DSU?
IT Questions Bank 2ITExamAnswers asked 12 months ago • 
Refer to the exhibit. Which two facts can be derived from this output? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which port should a terminal emulator be connected to in order to access a router without network connectivity?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. A device is required to complete the connection between router R1 and the WAN. Which two devices can be used for this? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Based on the output from the show running-config and debug ip rip commands, what are two of the routes that are added to the routing table of R1? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which three statements about routing protocols are true? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 12 months ago • 
Which statement is true regarding routing metrics?
IT Questions Bank 2ITExamAnswers asked 12 months ago • 
Refer to the exhibit. The results of the show ip route command are displayed in the graphic for Router R2. Which route will be selected for a packet with a destination address of 10.1.4.1?
IT Questions Bank 2ITExamAnswers asked 12 months ago • 
What are two functions of a router? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • , , , , , ,
Which two statements are true regarding classless routing protocols? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • , ,
When would the network administrator use the ip bandwidth-percent eigrp as-number percent command?
IT Questions Bank 2ITExamAnswers asked 3 years ago • , ,
What does OSPF use to reduce the number of exchanges of routing information in networks where large numbers of neighbors are present? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
Refer to the exhibit. What does the state “FULL/ -” indicate?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
What does VLSM allow a network administrator to do?
IT Questions Bank 2ITExamAnswers asked 2 years ago • ,
« Previous1…56789…34Next »
Ask Question