IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4Which two statements correctly describe the concepts of administrative distance and metric? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4, CCNA 2 v6A router has EIGRP configured as the only routing protocol. In what way might EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator is accessing router R1 from the console port. Once the administrator is connected to the router, which password should the administrator enter at the R1> prompt to access the privileged EXEC mode?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The output of the show ip route command for router R1 is displayed. What action will the router take for a packet that is destined for 192.168.1.5?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which two components are required to complete the configuration? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator uses the RIP routing protocol to implement routing within an autonomous system. What are two characteristics of this protocol? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers are properly configured to use the EIGRP routing protocol with default settings, and the network is fully converged. Which statement correctly describes the path that the traffic will use from the 10.1.1.0/24 network to the 10.1.2.0/24 network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Both routers are using the RIP protocol. Devices on the 192.168.1.1 network can ping the S0/0/0 interface on R2 but cannot ping devices on the 192.168.2.1 network. What is a possible cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The routers are properly configured using a dynamic routing protocol with default settings, and the network is fully converged. Router A is forwarding data to router E. Which statement is true about the routing path?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The show cdp neighbors command was run at R1. Which two facts about the newly detected device can be determined from the output? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. To implement the RIPv2 protocol, the network administrator runs the commands as displayed. However, the show ip protocol command fails to display any output. How can the administrator solve the problem that is indicated by the lack of output from this command?ITExamAnswers asked 2 years ago • CCNA 2 v4A network is configured with the IP, IPX, and AppleTalk protocols. Which routing protocol is recommended for this network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What action will R2 take for a packet that is destined for 192.168.2.0?ITExamAnswers asked 2 years ago • CCNA 2 v4Which two statements are true regarding link-state routing protocols? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4When a router boots, what is the default order to locate the Cisco IOS if there is no boot system command?ITExamAnswers asked 2 years ago • CCNA 2 v4