IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4Refer to the exhibit. All router interfaces are configured with an IP address and are operational. If no routing protocols or static routes are configured, what information will be included in the show ip route command output for router A?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which router is advertising subnet 172.16.1.32/28?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the function of the OSPF LSR packet?IT Administrator asked 4 years ago • CCNP, CCNA 2 v4Which two components are used to determine the router ID in the configuration of the OSPF routing process? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4What are two tasks that must be completed before two routers can use OSPF to form a neighbor adjacency? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Which two statements are correct about the split horizon with poison reverse method of routing loop prevention? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network administrator is planning IP addressing of a new network. What part of this addressing scheme must be changed to allow communication between host A and the server?ITExamAnswers asked 2 years ago • CCNA 2 v4Which three statements describe the operation of routing with EIGRP? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4All routers in a network are configured in a single OSPF area with the same priority value. No loopback interface has been set on any of the routers. Which secondary value will the routers use to determine the router ID?ITExamAnswers asked 2 years ago • CCNA 2 v4Which statement is true about the RIPv1 protocol?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Packets destined to which two networks will require the router to perform a recursive lookup? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v4How does route poisoning prevent routing loops?ITExamAnswers asked 2 years ago • CCNA 2 v4What command would the network administrator apply to a router that is running OSPF to advertise the entire range of addresses included in 172.16.0.0/19 in area 0?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which statement is true concerning the routing configuration?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator needs to assign the very last usable IP address in the 172.24.64.0/18 network range to the router interface that serves this LAN. Which IP address should the administrator configure on the interface?ITExamAnswers asked 2 years ago • CCNA 2 v4