IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v5In the creation of an IPv6 ACL, what is the purpose of the implicit final command entries, permit icmp any any nd-na and permit icmp any any nd-ns ?IT Administrator asked 3 years ago • CCNA 2 v5, CCNA SecurityIn applying an ACL to a router interface, which traffic is designated as outbound?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v5, CCNA Security, Network DefenseWhich set of access control entries would allow all users on the 192.168.10.0/24 network to access a web server that is located at 172.17.80.1, but would not allow them to use Telnet?ITExamAnswers asked 4 years ago • CCNP, CCNA 2 v5What range of IP addresses is represented by the network and wildcard mask 172.16.32.0 0.0.15.255?ITExamAnswers asked 9 months ago • CCNA 2 v5What range of IP addresses is represented by the network and wildcard mask 192.168.70.0 0.0.1.255?ITExamAnswers asked 9 months ago • CCNA 2 v5What range of IP addresses is represented by the network and wildcard mask 192.168.70.0 0.0.0.127?ITExamAnswers asked 9 months ago • CCNA 2 v5Refer to the exhibit. With the default metric settings, the OSPF cost for R1 to reach the network 172.16.1.0 isITExamAnswers asked 9 months ago • CCNA 2 v5Which statement describes a difference or similarity between OSPFv2 and OSPFv3?ITExamAnswers asked 4 years ago • CCNP, CCNA 2 v5What are three entries that are displayed by the show ip ospf neighbor command? (Choose three.)ITExamAnswers asked 3 years ago • CCNA 2 v5, CCNPA network administrator configures a loopback interface as the OSPF router ID with the IP address of 192.168.1.1/30. What could be the consequence of using this 30-bit mask for the loopback interface?ITExamAnswers asked 9 months ago • CCNA 2 v5The OSPF hello timer has been set to 15 seconds on a router in a point-to-point network. By default, what is the dead interval on this router?IT Administrator asked 3 years ago • CCNA, CCNA 2 v5, CCNPWhat does the number 11 represent?ITExamAnswers asked 4 years ago • CCNA 2 v5Which statement is correct about multiarea OSPF?IT Administrator asked 3 years ago • CCNA, CCNA 2 v5Which OSPF wildcard mask would be appropriate to use for the given network prefix?ITExamAnswers asked 9 months ago • CCNA 2 v5At which OSPF state are neighbor routers converged and able to exchange routing updates?ITExamAnswers asked 3 years ago • CCNA, CCNA 2 v5, CCNP