IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v5What type of static route is created when the next-hop IP address and exit interface are specified?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 2 v5A network administrator enters the following command into Router1: ip route 192.168.0.0 255.255.255.0 S0/1/0. Router1 then receives a packet that is destined for 192.168.0.22/24. After finding the recently configured static route in the routing table, what does Router1 do next to process the packet?ITExamAnswers asked 2 years ago • CCNA 2 v4, CCNA 2 v5Which option shows a correctly configured IPv4 default static route?ITExamAnswers asked 4 years ago • CCNA 2 v5Which of the following are three characteristics of a static route? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5A router-on-a-stick configuration will not allow PC1 on VLAN 10 to communicate with PC2 on VLAN 11. Which two of the following could be the problem? (Choose two.)ITExamAnswers asked 9 months ago • CCNA 2 v5What command would be used to determine if all SVIs were “up and up” on a multilayer switch?ITExamAnswers asked 9 months ago • CCNA 2 v5How many physical interfaces are required to perform inter-VLAN routing with each method indicated?ITExamAnswers asked 9 months ago • CCNA 2 v5A network technician is configuring a router to support inter-VLAN routing. After entering interface G0/0 configuration mode, the network administrator attempts to enter the command encapsulation dot1q 10. The router refuses to accept this command. What could account for this failure?ITExamAnswers asked 9 months ago • CCNA 2 v5Which three options are valid inter-VLAN routing methods? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5What are three advantages of having a single trunk link on a switch and subinterfaces on the router instead of individual VLAN links between a switch that has three VLANs and a router to route between the VLANs? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 2 v5Classify each item as either router-on-a-stick, Layer 3 switch routing, or both.ITExamAnswers asked 9 months ago • CCNA 2 v5Classify each item as either physical interface or subinterface.ITExamAnswers asked 9 months ago • CCNA 2 v5The output of the show ip route command contains the following entry: S 10.2.0.0 [1/0] via 172.16.2.2. What value is indicated by the 1 in the [1/0] portion of the output?ITExamAnswers asked 2 years ago • CCNA, CCNA 2 v5What code is used in the routing table to identify routes learned through EIGRP?ITExamAnswers asked 9 months ago • CCNA 2 v5Refer to the exhibit. What is the purpose of the router port that is shown?ITExamAnswers asked 9 months ago • CCNA 2 v5