IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v6A network designer must provide a rationale to a customer for a design that will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6What is a basic function of the Cisco Borderless Architecture distribution layer?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6What is different between IPv6 routing table entries compared to IPv4 routing table entries?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which type of route requires a router to perform a recursive lookup?ITExamAnswers asked 2 years ago • CCNA 2 v6Which route is the best match for a packet entering a router with a destination address of 10.16.0.2?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which two requirements are used to determine if a route can be considered an ultimate route in a router’s routing table? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6A destination route in the routing table is indicated with a code D. Which kind of route entry is this?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA SecurityHaving configured RIPv2 on an enterprise network, an engineer enters the command network 192.168.10.0 into router configuration mode. What is the result of entering this command?ITExamAnswers asked 2 years ago • CCNA 2 v6What is the purpose of the passive-interface command?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which dynamic routing protocol was developed as an exterior gateway protocol to interconnect different Internet providers?ITExamAnswers asked 4 years ago • CCNA 2 v6What is a disadvantage of using dynamic routing protocols?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?ITExamAnswers asked 4 years ago • CCNA 2 v6, CCNA 2 v7Which three IOS troubleshooting commands can help to isolate problems with a static route? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Assume the administrator has entered the ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 command. How would an administrator test this configuration?ITExamAnswers asked 2 years ago • CCNA 2 v6, CCNA 2 v7What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 2 v6