IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v6Which type of static route that is configured on a router uses only the exit interface?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6What is the correct syntax of a floating static route?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Why would a floating static route be configured with an AD that is higher than the AD of a dynamic routing protocol that is running on the same router?ITExamAnswers asked 2 years ago • CCNA 2 v6What command will enable a router to begin sending messages that allow it to configure a link-local address without using an IPv6 DHCP server?ITExamAnswers asked 4 years ago • CCNA 2 v6What are two common types of static routes in routing tables? (Choose two)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6A network administrator configures a router using the command ip route 0.0.0.0 0.0.0.0 209.165.200.226. What is the purpose of this command?ITExamAnswers asked 2 years ago • CCNA 2 v6A network administrator configures interface G0/0 on R1 with the ip address 172.16.1.254 255.255.255.0 command. However, when the administrator issues the show ip route command, the routing table does not show the directly connected network. What is the possible cause of the problem?ITExamAnswers asked 2 years ago • CCNA 2 v6Refer to the exhibit. A network administrator issues the show ipv6 route command on R1. What two conclusions can be drawn from the routing table? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6Consider the following routing table entry for R1: D 10.1.1.0/24 [90/2170112] via 209.165.200.226, 00:00:05, Serial0/0/0 What is the significance of the Serial0/0/0?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, DevNetWhat route would have the lowest administrative distance?ITExamAnswers asked 4 years ago • CCNA 2 v6Refer to the exhibit. What will the router do with a packet that has a destination IP address of 192.168.12.227?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6Which two items are used by a host device when performing an ANDing operation to determine whether a destination address is on the same local network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6A packet moves from a host on one network to a device on a remote network within the same company. In most cases, which two items remain unchanged during the transfer of the packet from source to destination? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v6What two pieces of information are displayed in the output of the show ip interface brief command? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 2 v7What is a characteristic of an IPv4 loopback interface on a Cisco IOS router?ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v6, CCNA 2 v7