IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v7What happens to a host in an HSRP network when the active router fails?ITExamAnswers asked 2 years ago • CCNA 2 v7When HSRP is used in a network, what destination MAC address is used in frames that are sent from the workstation to the default gateway?ITExamAnswers asked 2 years ago • CCNA 2 v7A network administrator is analyzing the features that are supported by different first-hop router redundancy protocols. Which statement describes a feature that is associated with VRRP?ITExamAnswers asked 2 years ago • CCNA 2 v7Which is a characteristic of the HSRP learn state?ITExamAnswers asked 2 years ago • CCNA 2 v7Which HSRP preemption statement is true?ITExamAnswers asked 2 years ago • CCNA 2 v7When SLAAC is used, which address will a client use as its default gateway?ITExamAnswers asked 2 years ago • CCNA 2 v7An organization requires that LAN clients generate their IPv6 configuration using SLAAC. You have configured the IPv6 GUA on the router LAN interface and verified that the interface is UP. However, hosts are not generating an IPv6 GUA. Which other command should be configured to enable SLAAC?ITExamAnswers asked 2 years ago • CCNA 2 v7A network administrator is implementing DHCPv6 for the company. The administrator configures a router to send RA messages with M flag as 1 by using the ipv6 nd managed-config-flag interface command, and the A flag is set to 0 using the ipv6 nd prefix default no-autoconfig command. What effect will this configuration have on the operation of the clients?ITExamAnswers asked 2 years ago • CCNA 2 v7An administrator wants to configure hosts to automatically assign IPv6 addresses to themselves by the use of Router Advertisement messages, but also to obtain the DNS server address from a DHCPv6 server. Which address assignment method should be configured?ITExamAnswers asked 4 years ago • CCNA 2 v7A network administrator configures a router to send RA messages with the A flag and O flag set to 1. The M flag is set to 0. Which statement describes the effect of this configuration when a PC tries to configure its IPv6 address?ITExamAnswers asked 2 years ago • CCNA 2 v7Which DHCP operation statement is true?ITExamAnswers asked 2 years ago • CCNA 2 v7Which command issued on R1 can be used to verify the current IPv4 address and MAC address binding?ITExamAnswers asked 2 years ago • CCNA 2 v7What is accomplished by the ip dhcp excluded-address 10.10.4.1 10.10.4.5 command?ITExamAnswers asked 2 years ago • CCNA 2 v7Which Windows command combination would enable a DHCPv4 client to reinstate its IPv4 configuration?ITExamAnswers asked 2 years ago • CCNA 2 v7Which interface configuration command will enable the port to establish an EtherChannel only if it receives PAgP packets from the other switch?ITExamAnswers asked 2 years ago • CCNA 2 v7