IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v7Which interface configuration command will enable the port to initiate an LACP EtherChannel?ITExamAnswers asked 2 years ago • CCNA 2 v7Which combination of channel-group modes will establish an EtherChannel?ITExamAnswers asked 2 years ago • CCNA 2 v7There has been an increase in network traffic between two Catalyst 2960 switches, and their FastEthernet trunk link has reached its capacity. How can traffic flow be improved?ITExamAnswers asked 2 years ago • CCNA 2 v7Which two statements regarding a PortFast enabled switch port are true? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7What is an advantage of using STP in a LAN?ITExamAnswers asked 2 years ago • CCNA 2 v7Which PVST+ feature ensures that configured switch edge ports do not cause Layer 2 loops if a port is mistakenly connected to another switch?ITExamAnswers asked 2 years ago • CCNA 2 v7What two features does Spanning Tree Protocol (STP) provide to ensure proper network operations? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7What are two advantages of using a Layer 3 switch with SVIs for inter-VLAN routing? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7What is a characteristic of a routed port on a Layer 3 switch? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7What are two disadvantages of using the router-on-a-stick inter-VLAN routing method in a large network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7Which router-on-a-stick command and prompt on R1 correctly encapsulates 802.1Q traffic for VLAN 20?ITExamAnswers asked 2 years ago • CCNA 2 v7What are the steps that must be completed in order to enable inter-VLAN routing using router-on-a-stick?ITExamAnswers asked 2 years ago • CCNA 2 v7Subinterface G0/1.10 on R1 must be configured as the default gateway for the VLAN 10 192.168.10.0/24 network. Which command should be configured on the subinterface to enable inter-VLAN routing for VLAN 10?ITExamAnswers asked 2 years ago • CCNA 2 v7You must configure a trunk link between a Cisco Catalyst 2960 switch to another vendor Layer 2 switch. Which two commands should be configured to enable the trunk link? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v7A Cisco Catalyst switch has been added to support the use of multiple VLANs as part of an enterprise network. The network technician finds it necessary to clear all VLAN information from the switch in order to incorporate a new network design. What should the technician do to accomplish this task?ITExamAnswers asked 4 years ago • CCNA 2 v7