You must configure a trunk link between a Cisco Catalyst 2960 switch to another vendor Layer 2 switch. Which two commands should be configured to enable the trunk link? (Choose two.)

IT Questions BankCategory: CCNA 2 v7You must configure a trunk link between a Cisco Catalyst 2960 switch to another vendor Layer 2 switch. Which two commands should be configured to enable the trunk link? (Choose two.)

You must configure a trunk link between a Cisco Catalyst 2960 switch to another vendor Layer 2 switch. Which two commands should be configured to enable the trunk link? (Choose two.)

  • switchport mode access
  • switchport mode dynamic auto
  • switchport mode dynamic desirable
  • switchport mode trunk
  • switchport nonegotiate

Explanation: To enable trunking from a Cisco switch to a device that does not support DTP, use the switchport mode trunk and switchport nonegotiate interface configuration mode commands. This causes the interface to become a trunk, but it will not generate DTP frames.

Exam with this question: 3.6.4 Module Quiz - VLANs

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments