IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Why is it advisable that a network administrator use SSH instead of Telnet when managing switches?ITExamAnswers asked 2 years ago • CCNA 3 v4Using the command copy tftp:backup.cfg startup-config, an administrator downloaded a saved configuration from a TFTP server to a switch. Why does the administrator not detect any changes in the switch configuration after the download completes?ITExamAnswers asked 2 years ago • CCNA 3 v4While configuring a new switch, a network administrator configures the switch as an HTTP server. What benefits does this configuration provide?ITExamAnswers asked 2 years ago • CCNA 3 v4Why is it important that the network administrator consider the spanning-tree network diameter when choosing the root bridge?IT Administrator asked 4 years ago • CCNP, CCNA 3 v4Which feature is uniquely found in an access layer switch within a hierarchical network model?ITExamAnswers asked 2 years ago • CCNA 3 v4In which mode is a VTP switch operating if it has been configured to only forward VTP advertisements?ITExamAnswers asked 2 years ago • CCNA 3 v4How does a switch that is configured for 802.1Q trunking handle untagged frames that are received on a trunk port?ITExamAnswers asked 2 years ago • CCNA 3 v4Which method establishes an administrative connection for configuring the Linksys WRT300N wireless access point?ITExamAnswers asked 2 years ago • CCNA 3 v4What three tasks should be performed before moving a Catalyst switch to another VTP management domain? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4What is the purpose of the switch command switchport access vlan 99?ITExamAnswers asked 2 years ago • CCNA 3 v4An administrator is troubleshooting a PC on the network which is suffering from slow and intermittent connectivity. The PC has a ping success rate to the default gateway of less than half the ping attempts. Other PCs on the switch can consistently ping the default gateway. The switch port is configured for auto duplex and the PC is configured for full duplex. What will commonly cause this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which value determines if a switch becomes the central point of reference in the spanning tree topology?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.65 and a destination address of 192.168.1.161. What will the router do with this packet?ITExamAnswers asked 2 years ago • CCNA 3 v4Which device must be installed in each computer to allow a wireless connection to be established?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switches SW3 and SW4 are brand new switches with default configurations. The links between the switches are configured as trunk links and all VLANs are allowed on the trunks. On the basis of the show running-config output that is provided, which VLANs will be available on SW3 and SW4?ITExamAnswers asked 2 years ago • CCNA 3 v4