IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Refer to the exhibit. A company has acquired a new office in a campus environment. Switches in the existing office and the new office are directly connected by a trunk link. The VLANs and IP addressing are setup as shown in the exhibit. The computers in each office are not able to ping each other. What will fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which layers should support QoS in a hierarchical network?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. A network administrator needs to download a previously saved configuration file from the TFTP server to Switch1. Which command will accomplish this task?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. After the listed commands are entered into router R1 and switch S1, PC1 and PC2 cannot ping each other. The network administrator enters the show interfaces trunk command and gets the results that are shown. What is the likely problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which statement accurately describes routing between VLANs when the default gateway addresses of the VLANs are applied to physical interfaces.ITExamAnswers asked 2 years ago • CCNA 3 v4After unpacking a new Linksys WRT300N wireless multifunction device, a user needs to change the default administrator password and make other configuration changes. What must the user do to access the device in order to make these changes?ITExamAnswers asked 2 years ago • CCNA 3 v4A network technician is investigating a problem on a switch that seems to have overflowing buffers and is dropping packets on many incoming ports. On examination the technician discovers that the problem exists because the destination port attaches to a busy server. What is the best way to address this problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Which benefit is gained by designing a network with a small network diameter?ITExamAnswers asked 2 years ago • CCNA 3 v4Which parameter is associated with wireless authentication?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What three statements describe why Host1 and Host2 are unable to communicate? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Host A is sending a frame to host C. How does switch SWA tag the frame?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which password allows the administrator to enter the privileged exec mode?ITExamAnswers asked 2 years ago • CCNA 3 v4What is a possible impact of setting too short an aging time in the MAC address table of a switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. After receiving a console notification on Switch2, the network administrator begins to troubleshoot the trunk link between Switch1 and Switch2. Which configuration change can be made to correct the problem with the trunk link?ITExamAnswers asked 2 years ago • CCNA 3 v4What purpose does authentication serve in a WLAN?ITExamAnswers asked 2 years ago • CCNA 3 v4