IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Refer to the exhibit. In what two ways will the router handle VLAN traffic that is received on the trunk? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. After the listed commands are entered into router R1 and switch S1, the administrator enters the show interface fa0/1 trunk and gets the results shown. What is the likely problem?ITExamAnswers asked 11 months ago • CCNA 3 v4When implementing a router-on-a-stick, what must be configured on the router to ensure connectivity between different VLANs?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. All trunk links are operational and all VLANs are allowed on all trunk links. An ARP request is sent by computer 5. Which device or devices will receive this message?ITExamAnswers asked 11 months ago • CCNA 3 v4Which device or devices should have the Spanning Tree Protocol enabled to prevent host traffic from creating a broadcast storm?ITExamAnswers asked 11 months ago • CCNA 3 v4Which type of frame contains information that is used in the election of the spanning tree root bridge?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What is the purpose of the configuration commands that are shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What will happen when frames with a source address other than 0019.d2e4.d9f7 enters interface Fa0/24?ITExamAnswers asked 2 years ago • CCNA 3 v4What are three benefits of employing a hierarchical network design? (Choose three.)ITExamAnswers asked 3 years ago • CCNP, CCNA 3 v4Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2. Hosts A, B, C, and D are correctly configured with IP addresses in the subnet range for VLAN 50. Host A can communicate with host B, but cannot communicate with host C or host D. What is the cause of this problem?ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. Which three options correctly describe the router configuration that is shown? (Choose three.)ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. All switches are configured with the default bridge priority. Which port will act as a non-designated port if all links are operating at the same bandwidth?ITExamAnswers asked 11 months ago • CCNA 3 v4What two methods can be used to remove MAC address table entries from a switch? (Choose two.)ITExamAnswers asked 11 months ago • CCNA 3 v4Refer to the exhibit. Users complain that they do not have connectivity to the web server that is connected to SW1. What should be done to remedy the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The hosts connected to switch SW1 are not able to communicate with the hosts in the same VLANs connected to switch SW2. What should be done to fix the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4