IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Refer to the exhibit. Switch SW2 has been newly purchased and added to the network. What configuration should be applied to SW2 so that it participates in the same VTP domain as switch SW1, receives VLAN information from SW1, and synchronizes VLAN information?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Switch SW2 was tested in a lab environment and then inserted into a production network without reloading its configuration. After the trunk link between SW1 and SW2 was brought up, all users lost connectivity to the network. What could be the source of the problem?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. How does SW1 manage traffic coming from Host A?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Router R-West and switch S-West1 are connected via a single ethernet cable between the router interface fa0/0 andthe switch interface fa0/1. The router and switch have been configured with the commands that are displayed in the exhibit. The networkadministrator enters the show interfaces trunk command and receives the output as shown. What is the cause of the “not-trunking”status for switch port Fa0/1?ITExamAnswers asked 12 months ago • CCNA 3 v4Refer to the exhibit. Computer D sends a broadcast message. Which devices will process the broadcast message?ITExamAnswers asked 12 months ago • CCNA 3 v4Which statement correctly describes the spanning-tree path cost?ITExamAnswers asked 2 years ago • CCNA 3 v4Which statement about STP network diameter is correct?ITExamAnswers asked 12 months ago • CCNA 3 v4Refer to the exhibit. Which switch will be elected as the root bridge of the spanning tree topology?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The Layer 2 switching design that is shown has been implemented in a campus environment that is using Spanning Tree Protocol. All inter-switch links that are shown are trunks. Whenever an inter-switch link fails, the network takes nearly a minute to completely converge. How can the convergence time be reduced?ITExamAnswers asked 2 years ago • CCNA 3 v4When configuring a router to act as an SSH server, what should be configured before issuing the crypto key generate rsa command?ITExamAnswers asked 12 months ago • CCNA 3 v4Refer to the exhibit. A network administrator configures HyperTerminal with the parameters shown but is unable to connect to a switchvia the console port. The administrator is using a tested rollover cable attached to the only COM port on the computer, and theconnections have been verified. What is the likely problem?ITExamAnswers asked 12 months ago • CCNA 3 v4Refer to the exhibit. What does STATIC indicate in the output that is shown?ITExamAnswers asked 12 months ago • CCNA 3 v4Refer to the exhibit. The devices in the network are operational and configured as indicated in the exhibit. However, hosts A and Dcannot ping each other. What is the most likely cause of this problem?ITExamAnswers asked 12 months ago • CCNA 3 v4The global configuration command ip default-gateway 172.16.100.1 is applied to a switch. What is the effect of this command?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v4, Networking Devices and Initial Configuration, Networking EssentialsWhat happens when the transport input ssh command is entered on the switch vty lines?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v4, CCNP, Networking Devices and Initial Configuration, Networking Essentials