IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v6Which two network design features require Spanning Tree Protocol (STP) to ensure correct network operation? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPTo obtain an overview of the spanning tree status of a switched network, a network engineer issues the show spanning-tree command on a switch. Which two items of information will this command display? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 3 v6Which STP priority configuration would ensure that a switch would always be the root switch?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6, CCNPIn which two port states does a switch learn MAC addresses and process BPDUs in a PVST network? (Choose two.)ITExamAnswers asked 4 years ago • CCNP, CCNA 2 v7, CCNA 3 v6What is an advantage of PVST+?IT Administrator asked 4 years ago • CCNA 2 v7, CCNA 3 v6Which is the default STP operation mode on Cisco Catalyst switches?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which STP port role is adopted by a switch port if there is no other port with a lower cost to the root bridge?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v6Which three components are combined to form a bridge ID? (Choose three.)ITExamAnswers asked 1 year ago • CCNA 2 v7, CCNA 3 v6What additional information is contained in the 12-bit extended system ID of a BPDU?ITExamAnswers asked 4 years ago • CCNP, CCNA, CCNA 3 v6What could be the effect of duplicate unicast frames arriving at a destination device due to multiple active alternative physical paths?ITExamAnswers asked 4 years ago • CCNA 3 v6What steps must be completed in order to enable inter-VLAN routing using router-on-a-stick?ITExamAnswers asked 1 year ago • CCNA 3 v6What two statements are true regarding the use of subinterfaces for inter-VLAN routing? (Choose two.)ITExamAnswers asked 1 year ago • CCNA 2 v7, CCNA 3 v4, CCNA 3 v6What distinguishes traditional legacy inter-VLAN routing from router-on-a-stick?ITExamAnswers asked 1 year ago • CCNA 2 v7, CCNA 3 v6A router has two FastEthernet interfaces and needs to connect to four VLANs in the local network. How can this be accomplished using the fewest number of physical interfaces without unnecessarily decreasing network performance?ITExamAnswers asked 1 year ago • CCNA 2 v7, CCNA 3 v4, CCNA 3 v6How are VTP messages sent between switches in a domain?ITExamAnswers asked 1 year ago • CCNA 3 v4, CCNA 3 v6