IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 4 v4Refer to the exhibit. Router R1 has been configured for Frame Relay connectivity to routers R2 and R3. Which set of configuration options for routers R2 and R3 would provide each router connectivity to R1?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which statement explains why the Frame Relay connection between R1 and R2 is failing?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What effect does the point-to-point configuration on subinterface S0/0.110 have on the operation of the router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be determined from the output?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. What can be determined about the Frame Relay switch from the output shown?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which two outcomes occur from the configuration shown? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Which two items allow the router to map data link layer addresses to network layer addresses in a Frame Relay network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Router R1 has been configured for Frame Relay connectivity to routers R2 and R3. What configuration option should be configured on the R2 and R3 serial interfaces in order for all routers to ping each other successfully?ITExamAnswers asked 2 years ago • CCNA 4 v4Which best describes the benefit of using Frame Relay as opposed to a leased line or ISDN service?ITExamAnswers asked 2 years ago • CCNA 4 v4Which three actions might a Frame Relay switch perform when it detects an excessive build-up of frames in its queue? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Router R1 is not able to communicate with a neighbor router that is directly connected to serial 0/0/0. What is the reason for this?ITExamAnswers asked 2 years ago • CCNA 4 v4Which PPP configuration option can be used to establish load balancing over the interfaces of a router?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which statement is true about PPP operation?ITExamAnswers asked 2 years ago • CCNA 4 v4What does the demarcation point represent in data communication physical circuits?ITExamAnswers asked 2 years ago • CCNA 4 v4Refer to the exhibit. Which two statements are true regarding the output shown? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4