IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Refer to the exhibit. The new security policy for the company allows all IP traffic from the Engineering LAN to the Internet while only web traffic from the Marketing LAN is allowed to the Internet. Which ACL can be applied in the outbound direction of Serial 0/1 on the Marketing router to implement the new security policy?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The following commands were entered on RTB. Which addresses do these commands block access to RTB?ITExamAnswers asked 7 months ago • CCNA Discovery v4What effect does the command reload in 30 have when entered into a router?ITExamAnswers asked 7 months ago • CCNA Discovery v4What can an administrator do to ensure that ICMP DoS attacks from the outside are mitigated as much as possible, without hampering connectivity tests initiated from the inside out?ITExamAnswers asked 7 months ago • CCNA Discovery v4ACLs are used primarily to filter traffic. What are two additional uses of ACLs? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNA 2 v5, CCNA Discovery v4, CCNA Security, CCNPTraffic from the 64.104.48.0 to 64.104.63.255 range must be denied access to the network. What wildcard mask would the network administrator configure in the access list to cover this range?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two host addresses are included in the range specified by 172.16.31.64 0.0.0.31? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4ACL logging generates what type of syslog message?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator of a company needs to configure the router RTA to allow its business partner (Partner A) to access the web server located in the internal network. The web server is assigned a private IP address, and a static NAT is configured on the router for its public IP address. Finally, the administrator adds the ACL. However, Partner A is denied access to the web server. What is the cause of the problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4ACLs more efficient for the router than outbound ACLsITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. A network administrator needs to add the command deny ip 10.0.0.0 0.255.255.255 any log to R3. After adding the command, the administrator verifies the change using the show access-list command. What sequence number does the new entry have?ITExamAnswers asked 7 months ago • CCNA Discovery v4What statement best describes cell switching?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two options can LCP negotiate? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4A company is implementing dialup services for remote workers to connect to the local network. The company uses multiple Layer 3 protocols and requires authentication for security. Which protocol should be used for this remote access?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator is configuring R1 to connect to R2, which is a non-Cisco router. Which encapsulation method will need to be configured for communication to occur?ITExamAnswers asked 7 months ago • CCNA Discovery v4