IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Why would a designer choose a flat network over a hierarchical network design?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. When creating an extended ACL to deny traffic from the 192.168.30.0 network destined for the Web server 209.165.201.30, where is the best location for applying the ACL?ITExamAnswers asked 2 years ago • CCNA 4 v4, CCNA Discovery v4Which two events occur when the command RTA(config)# frame-relay map ip 10.1.1.1 22 is issued on a router? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4When should a network designer specify that a dedicated firewall appliance be used at the perimeter of the network rather than a router with a Cisco IOS software-based firewall feature set?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What does the JAX router do with traffic that is destined for a web server with an IP address of 128.107.10.24?ITExamAnswers asked 7 months ago • CCNA Discovery v4What are two suggested best practices to implement when securing network devices? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4During prototype testing, the network designer performs a test to determine the ability of the network to recover from a link or device failure. Which design goal is validated if the test is a success?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The two switches that are shown will not form a trunk. What is the most likely cause of this problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Following a test plan, the network systems engineer completes the configuration of an access layer switch and connects three PCs to test the configuration. The engineer attempts to ping from each PC to the other connected PCs. Which three statements describe the expected results of pinging from one host to another? (Choose three.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What can the field engineer conclude about the EIGRP authentication between RouterA and RouterB?IT Administrator asked 3 years ago • CCNA Discovery v4, CCNPAn HWIC-4ESW, four-port switch module needs to be installed in a Cisco 1841 router that currently has a WIC-2T module in slot 0. What should the network technician do first?ITExamAnswers asked 7 months ago • CCNA Discovery v4After performing a password recovery operation on a router, the network field engineer copies the running configuration to the startup configuration and then reloads the router. The router boots successfully but immediately enters the setup mode. The engineer manually loads the startup configuration using the copy start run command and verifies that the configuration is correct and the passwords are reset. What can cause the router to enter setup mode rather than load the correct startup configuration file?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What is the spanning-tree role of all the enabled interfaces of SW11?ITExamAnswers asked 7 months ago • CCNA Discovery v4During a review of the proposed bill of materials, the ABC Networking Company account manager realizes that the systems engineer included a lower cost, less capable switch model for the access layer connectivity than was specified by the network designer. When questioned, the systems engineer responds that the switches that were recommended by the designer cannot be purchased within the budget limitations of the customer. Which action should the account manager take?ITExamAnswers asked 7 months ago • CCNA Discovery v4A customer has asked a network engineer to prototype the new IP addressing and summarization strategy for a large, multisite network implementation. Which tool is appropriate for testing the complete addressing scheme?ITExamAnswers asked 7 months ago • CCNA Discovery v4