IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAA network administrator is configuring a WLAN. Why would the administrator change the default DHCP IPv4 addresses on an AP?ITExamAnswers asked 4 years ago • CCNAA network administrator is configuring a WLAN. Why would the administrator change the default DHCP IPv4 addresses on an AP?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. R1 is configured for NAT as displayed. What is wrong with the configuration?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator issues the show ip protocols command. Based on the exhibited output, what can be concluded?ITExamAnswers asked 4 years ago • CCNA, CCNPA network administrator uses the spanning-tree portfast bpduguard default global configuration command to enable BPDU guard on a switch. However, BPDU guard is not activated on all access ports. What is the cause of the issue?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which two configurations will allow router R1 to establish a neighbor relationship with router R2? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers as shown. The routers are unable to form a neighbor adjacency. What should be done to fix the problem?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Why are routers R1 and R2 not able to establish an OSPF adjacency?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Remote users are experiencing connectivity problems when attempting to reach hosts in the 172.21.100.0 /24 network. Using the output in the exhibit, what is the most likely cause of the connectivity problem?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat two values must match between two EIGRP directly connected neighbors to establish and maintain an adjacency? (Choose two.)ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. R3 has two possible paths to the 172.16.99.0 network. What is the reported distance of the feasible successor route?ITExamAnswers asked 4 years ago • CCNA, CCNPWhich QoS technology provides congestion avoidance by allowing TCP traffic to be throttled before buffers become full and tail drops occur?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. A network administrator is viewing the output from the command show ip nat translations. Which statement correctly describes the NAT translation that is occurring on router RT2?ITExamAnswers asked 4 years ago • CCNA, CCNPRefer to the exhibit. Which two events occur on the interface, if packets from an unknown Source address arrive after the interface learns the maximum number of secure MAC address? (Choose two.)MD Villarama answered 3 years ago • CCNAWhat is the function of the HTTP GET message?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOps